Hung straight, wired right
Light Fixture Installation in Gilbert, AZ
That new chandelier looks great in the box. Getting it on the ceiling — level, solid, and safe — is another story. Fixture swaps look simple on video until you find three cables where you expected two, a box that cannot hold the weight, or wiring with no ground. That is when homeowners call us.
AC/DC Electric installs light fixtures all over Gilbert and the East Valley: chandeliers, pendants, vanity bars, flush mounts, exterior sconces. We quote flat before we start, we check the box and the wiring before anything hangs, and we leave the fixture straight and the room clean.
Watch for these
Signs that old fixture has to go
- The fixture flickers, hums, or buzzes
- Bulbs keep burning out in one spot
- Scorch marks or heat around the fixture base
- It wobbles every time a door slams
- The finish is yellowed, pitted, or dated
- You bought a fixture heavier than the old one
Why heavy fixtures need more than a screw in drywall
A standard ceiling box is only rated to carry so much — roughly 50 pounds under the code. A big two-tier chandelier can blow past that. Heavy fixtures need a box listed for the load and anchored to framing, not just fastened to drywall. We check what is up there before your fixture goes up, and if the box is not up to the job, we replace and brace it. That is the difference between a showpiece and a crash.
Two-story foyers and tall ceilings
High installs are where DIY gets dangerous. We bring the right ladders and staging for two-story entryways, stairwell fixtures, and vaulted great rooms. We also set chain and cord length so the piece hangs at the correct height over your table or entry floor. One trip, done right, no borrowed scaffolding involved.
Why AC/DC Electric
We treat a simple flush mount with the same care as a foyer chandelier: licensed, bonded, and insured work, drop cloths down, flat pricing agreed before the ladder opens. And if the job turns out to need more than a swap — a new switch leg, a braced box, updated wiring — we handle that on the spot instead of leaving you with a half-finished ceiling. Around the clock, 7 days a week.
Need an electrician now?
Call anytime — nights, weekends, holidays. A licensed electrician answers.
FAQ
Straight answers
Can you install a light where there is no fixture now?
Yes. We can run a new switch leg, cut in a rated box, and fish cable through the attic or wall with minimal drywall damage. Where cutting is unavoidable, we tell you up front so you can plan for patch and paint. You get a flat quote before we open anything.
My new LED fixture flickers on the old dimmer. Why?
Old incandescent dimmers and modern LED drivers often do not get along — you get flicker, buzz, or a light that never fully turns off. The fix is a dimmer rated for your fixture's LED load. We match them all the time; see our [dimmer switch installation](/services/dimmer-switch-installation-gilbert-az) page.
How high should a chandelier hang over a dining table?
The common rule of thumb is 30 to 36 inches between the tabletop and the bottom of the fixture for a standard-height ceiling, a bit higher for taller rooms. We set the chain or cord length during the install and check it with you before we tighten everything down, so it looks right from every seat.
Can you swap a light fixture for a ceiling fan?
Often, yes — but not always directly. Fans put spinning, vibrating load on the box, so code requires a fan-rated box, which most light-only boxes are not. We verify the box, replace it if needed, and hang the fan properly. Details live on our [ceiling fan installation](/services/ceiling-fan-installation-gilbert-az) page.
Residential Electrical
Related services
Serving the East Valley & Phoenix Metro
Light Fixture Installation — available 24/7 in Gilbert, Chandler, Tempe, Mesa, Phoenix, Scottsdale and the surrounding area.
Light Fixture Installation — done right
Upfront pricing, licensed work, 24/7 response. One call does it.